Anti-smoke Belching Device...

add616reneb
IT Consultant
Have you installed any anti-smoke belching device in your car? Is it really effective in reducing the smoke produced by incomplete combustion of the fuel (Diesel or Gas) in your engine?
0
Comments
-
IMO, anti-smoke belching devices (are there any?) would mean that your not solving the problem at the source. The best would be to maintain your rides well.
With gas engines, adjust the air-fuel mixture to spec (stoichiometric?), get a change oil and tune-up regularly and the car should be fine unless its already running on loose compression or something. With diesels, changing the fuel filters, air filter, keeping the fuel lines clean and making sure the injection pump is runnign up to spec will help keep the emissions minimal when coupled with a regular change oil job.
There are also Catalytic converters which help reduce toxic emission gasses.0 -
Originally posted by slamm
IMO, anti-smoke belching devices (are there any?) would mean that your not solving the problem at the source. The best would be to maintain your rides well.
With gas engines, adjust the air-fuel mixture to spec (stoichiometric?), get a change oil and tune-up regularly and the car should be fine unless its already running on loose compression or something. With diesels, changing the fuel filters, air filter, keeping the fuel lines clean and making sure the injection pump is runnign up to spec will help keep the emissions minimal when coupled with a regular change oil job.
There are also Catalytic converters which help reduce toxic emission gasses.
There is a Filipino inventor (Mr. Adolfo Alegre) who came up with an anti-smoke belching device using the principle of VENTURI EFFECT. The device is attached to the muffler where it sucks out all impurities (like a vacuum cleaner), promote more complete fuel combustion, increase engine HP and guaranteed to reduce emission within minutes after installation! The effect is like having a rocket-powered engine. The device is called ALEGRE EXHAUST GAS OXIDIZER (EGO).0 -
Originally posted by slamm
I ran over one in an ad in the papers today on one of the devices.There was also this device before called "Aerogas" but i havent seen any actual useage yet. This one was used i think in the combustion process (i.e. connected to the carburator in non EFI cars)
Our company tested the "Aerogas" Catalytic Combustor but unfortunately it did not live to its claims of lesser emmissions. However, when we tested the EGO (Exhaust Gas Oxidizer) of Mr. Alegre, his device really works. There is a noticeable increase in engine power (about 5 - 8%) and fuel savings of about 15% and the smoke really was minimized/gone in about 1 - 3 minutes! Ther tests were done in a 1993 Toyota Land Cruiser (Prado) which was really a smoke-belching vehicle before EGO was installed.0 -
Originally posted by Dina_DJ
How much is this "Aerogas" device? And where can I score one? You just slap it on to you muffler and that's it? No other modifications to your vehicle? Sounds interesting.
The "Aerogas" device asper result of our testing is not effective and it is not installed in the muffler but rather near the engine side. The one attached to the muffler is the Alegre EGO (Exhaust Gas Oxidizer" and is really effective due to "venturi effect". The EGO is made of stainless steel and costs P 4,500/device for small cars; P5,500/device for medium cars/vehicles and P 6,500/device for trucks/buses. We are planning to market the EGO and you could score one from me.0 -
Get your Alegre EGO now and install at the exhaust muffler/tail pipe and make smoke-belching a thing of the past... Support the Clean Air Act!0
-
HOW THIS BREAKTHROUGH INVENTION (EGO)
WORKS EFFECTIVELY THREE WAYS...
With the installation of EGOdevice (Alegre EXHAUST GAS OXIDIZER) to the present Conventional Exhaust System of an engine or vehicle, the exhaust flow velocity is increased tremendously by the venturi function of the device, causing more efficient scavenging in the engines combustion chambers. As a result, all the leftover wastes (unburnt fuel) and carbon deposits are scavenged and dispersed out during the exhaust stroke; thus, the subsequent intake of fresh fuel into the combustion chambers is assured to be in its ideal mixture or in the homogeneous state of stoichiometric air-fuel-ratio for efficient, full power combustion. This scientific innovation attributed to the EGO devices amazing accom-plishment, warrant an all-time peak engine performance, insuring:
(1) Controlled exhaust emission to the safest level;
(2) Substantial fuel and oil savings ( Gasoline from 25%- 30%; Diesel from 15%- 20%);
(3) Remarkable power and torque increased (5%- 8%).
Furthermore, the resulting effect of the exhaust emissions increased velocity flow passing rapidly through the exhaust piping system and the EGO device, causes partial vacuum in its venturi section, which automatically draws-in atmos-pheric air inside the device. In this process, oxygen from the inducted air reacts to the hot gases of exhaust; thus, further oxidation of the unburnt hydro-carbons take place, and in consequence, converts these noxious gases into harmless carbon dioxide, water and traces of Nitrogen as they are expelled-out clean and friendly to the atmosphere.
Install One Now!!!0 -
Originally posted by kit7kat
San nyo ba minamarket yang alegre EGO na yan..networking ba yan?
The Alegre EGO Device is now one of the products (Under Automotive) in our Internet Mall. CYBERLINK recently got the exclusive Online Dealership rights from Mr. Adolfo Alegre, the Inventor of the EGO Device. So anybody with an Bancnet/ Megalink ATM card could purchase one via the Internet (Visit: www.cyberlink.net.ph).0 -
CONVENTIONAL EXHAUST SYSTEM:
Exhaust Emission is pushed out by the force of pistons at normal exhaust pressure flow velocity, leaving inside the
combustion chambers some sticky gums, unburnt fuel and carbons affecting the mixture of the subsequent induction of fresh fuel thereby resulting to inefficient combustion.
Versus
EGO DEVICE ADAPTED TO CONVENTIONAL EXHAUST SYSTEM:
Exhaust flow velocity is increased tremendously by the Venturi system of the EGO device causing more effi-
cient scavenging in the engines combustion chambers, resulting to efficient dispersal of all leftover wastes (unburnt
fuel) and carbon deposits; thus, the subsequent intake of fresh fuel is assured to be in its ideal mixture, for efficient, full
power combustion. This scientific innovations warrant an all-time peak engine performance, insuring: (a) CONTROLLED
EXHAUST EMISSION, (b) SUBSTANTIAL FUEL SAVINGS and (c) REMARKABLE INCREASE in POWER and TORQUE0 -
The ALEGRE EGO (EXHAUST GAS OXIDIZER) is one of the finalists in this year's Inventors' Week to be held in PHILTRADE (Buendia corner Roxas Blvd., Pasay City, MM) starting this coming November 26th, 2003. Come and see for yourselves the device in action!!!0
-
Originally posted by buknoyqqq
how longwill the ego device last?
are there consumable materials that need to be replaced during the device's life like filters etc.
does it come with a money back guarantee?
The device will be welded at the tip of your tail pipe by oxy-acetylene. No engine modifications what so ever. No parts to be replaced, and no filters, etc. The device is made of stainless steel (with lifetime warranty) and will outlast even the vehicle itself! You can transfer it to another vehicle. Limited money back guarantee. Visit PHILTRADE 9AM - 5PM for actual FREE Demo until Sunday, Nov. 30th, 20030 -
Originally posted by buknoyqqq
where can i see the product for demo? cant go to philtrade this weekend
Where do you live? Give me a call (02)8740183 or text me at (0926)3031871 your landline nos. Ty.
Closing ceremonies at PHLITRADE for National Inventors' Week at 3pm Sunday. Nov. 30th. We'll still be there staring 10AM.
Rene0 -
The ALEGRE EXHAUST GAS OXIDIZER (EGO) recently won FIRST PRIZE (Likha Award) in this year's National Inventors' Week competition held at PHILTRADE last Nov. 26th - 30th, 2003!0
-
Interesting thread: http://www.tsikot.com/forums/showthread.php?s=&threadid=9335&perpage=15&pagenumber=1
The in-house engineer (that would be yebo) vs. the EGO
Yebo is in no way affiliated with Tsikot.com nor any of our sister sites. He just likes hanging around at Tsikot.com0 -
The EGO is now being marketted at special introductory prices.
The device costs from P4,500 - P6,500 only depending on models and sizes of the engines but excluding cost of welding as follows:
Price ranges for the five (5) EGO- size Models:
EGO-1SM (for 1000cc-1500cc engines) PhP4,500
EGO-1 (for 1600cc-2000cc engines) PhP4,500
'EGO-1XL (for 2.2 lt. 3.0 lt. engines) PhP5,500
EGO-2 (for 3.2 lt. 3.5 lt. engines) PhP6,000
EGO-2XL (for Extra large engines) PhP6,500
You could get the devices from me (Res. Tel. 8740183 BFRV, Las Piñas,MM) or Txt at: (0926)3031871. You could also be one of our Dealers subject to certain requirements.0
Welcome to PinoyExchange!
Forums
- 4.5K All Categories
- 27.1K PEx Sports
- 56.7K PEx Local Entertainment
- 30.4K PEx International Entertainment
- 41.7K PEx Lifestyle
- 26.8K PEx Hobbies
- 64.1K PEx News and Tech
- PEx Business and Careers
- 44.5K PEx Family and Society
- 25.3K PEx Relationships
- 13.1K PEx Chat
- 29.5K PEx Campus
- 32.3K PEx Classifieds
- 703 PEx Community
In this Discussion
- add616reneb 24 posts
- Ischaramoochie 5 posts
- pyramid00 4 posts
- slamm 2 posts
- buknoyqqq 2 posts
- billyray 1 post
- travy 1 post
- Dina_DJ 1 post
- PlutoPlays 1 post
- vaevictis 1 post